www.TurkishVirtual.com - As Real As It Gets, Since 2001
THY4100 wrote:I am using a lua script to solve my light problems. I had a persistent NAV Light On issue.
It also allows you to switch lights from 3D cockpit without FDR aircraft systems pop up but I highly recommend keeping aircraft systems on all times for monitoring.
It has a version which guesses baro reference from reading the capt. side knob, it works fine for me but I can't guarantee it being reliable. So again, keep FDR aircraft systems screen on. Redundancy is always a good practice in aviation.
I also have to say, this is literally the unapproved method from Turkish Virtual. Apparently it was too sketchy/not reliable enough to be official fix.
So your mileage may vary.
https://drive.google.com/open?id=1B4LPcZQU7q0fAGRKNtXdn3CIbRqTxGOU
THY4100 wrote:We don't have access to landing light switch positions, FSLabs' LVars are really limited. They stated they will open more with a SDK, but it will require an additional professional license(!).
What we can read is "L:FSLA320_landing_lightX_vis" which is light visibility from individual landing lights (1 & 2). So it is for animation and/or graphics. When both landing lights are "shining" it should set FSUIPC offset "on" and when any of them is off it should set offset "off".
This problem never happened to me but my guess is that it can be related to graphics. Wild guess, maybe FSLabs doesn't set these LVars accordingly when we don't see the lights. Or maybe lights themselves are not working properly.
You can try to power the aircraft, go to external view and check if the lights are extended/on. Note that sometimes lights extending takes some time, they will be lit once they are fully extended. If offset (therefore FDR) is not in sync with visual state of the lights then we can conduct a further investigation. But I am very doubtful we can do much with this limited access to aircraft systems.
Until FSLabs provides a better access to aircraft systems keep your keybinds to lights, QNH and monitor FDR's pop up.
Finally, you are more than welcome, I wish I could do more.
Users browsing this forum: No registered users and 3 guests